Buscar
Mostrando ítems 81-90 de 148
Managing Manufacturing Maturity and Risks by Applying Department of Defense Manufacturing Readiness Assessment and Manufacturing Readiness Levels Process to a Military Weapons System
(Polytechnic University of Puerto Rico, 2015)
In the 1990’s the Department of
Defense, as part of the Acquisition Process Reform,
started reducing and eliminating Manufacturing and
Quality Assurance instructions, guidance, Mil-Specs
and Standards, relying on the ...
A Study on the Effects of Plastic Shrinkage Cracking of Shotcrete Mixes Applied over a Dry Clay Base While Exposed to the Sun and Wind
(Polytechnic University of Puerto Rico, 2015)
Thin concrete shells used as concrete
liners over dry clay dikes suffer from plastic
shrinkage cracking for two main reasons: the dry
clay base absorbs some of the water in the concrete
from below, and high heat coupled ...
Combination Products Regulation – A Guide to Compliance
(Polytechnic University of Puerto Rico, 2015)
The Food and Drug Administration
(FDA or Agency) has issued a regulation on the
current good manufacturing practices (CGMP’s)
requirements applicable to combination products.
The new rule is intended to promote the ...
Using Wireshark in a Medical Office
(Polytechnic University of Puerto Rico, 2015)
This project is about sniffing the packets
in a secured network with electronic health record
(EHR) while using Wireshark. I suspect that the
packets and the network are going to be encrypted
and it won’t be possible ...
BU2 MIDS LVT
(Polytechnic University of Puerto Rico, 2015)
This project studies the considerations,
implications and challenges of implementing a
block upgrade to the link 16 terminals of several
fleets of United States Air Force aircrafts. The
block upgrade will try to ...
CFD Study to Analyze the Behavior of Secondary Flow Using Fillets
(Polytechnic University of Puerto Rico, 2015)
Secondary flow are a series of vortex
created at the leading edge of the blade. These
vortexes decrease the efficiency of the turbine by
creating a non-uniform flow which will pass to
successive blade stages. The ...
Tecnologías de Uso Libre para el Desarrollo de un Sistema de Información Geográfica como Herramienta para la Participación Pública
(Polytechnic University of Puerto Rico, 2015)
El propósito de este trabajo es diseñar
un Sistema de Información Geográfica utilizando
tecnologías de uso libre que provea para la
participación pública, permitiendo así establecer
un mecanismo adicional para el ...
Desarrollo de Mapas en GIS para Futura Planificación en Áreas de Impacto debido al Aumento del Nivel del Mar en Puerto Rico
(Polytechnic University of Puerto Rico, 2015)
El fenómeno del Calentamiento Global
es un tema de mucha importancia mundialmente,
por tal razón, necesitamos estudiar y conocer los
efectos en nuestra Isla de Puerto Rico y las áreas
de mayor impacto. Nuestro objetivo, ...
Implementation of Stryker® Pay to Minimize Check Fraud and Improve Check Printing
(Polytechnic University of Puerto Rico, 2015)
The intent of the project, Stryker® Pay,
was to replace the check printing process in
Stryker®. The application will be capable of
converting the check information obtained from the
ERP system into a PayBase (off the ...
Measuring and Improving the Quality of Service from the Customer's Perspective in an Emergency Room using Lean Thinking
(Polytechnic University of Puerto Rico, 2015)
Lean is a philosophy and a powerful
set of tools designed for process improvement by
eliminating waste from processes. It also focuses
on what adds value in processes from a customer's
perspective. The quality of a ...