Buscar
Mostrando ítems 81-90 de 186
The 2017-2018 Evaluation of the National Operational Excellence Index in Puerto Rico
(Polytechnic University of Puerto Rico, 2019-08-19)
Puerto Rico has not participated in the evaluation of the World Forum Competitive Index
(WFCI) since 2015; consequently, the Puerto Rico Manufacturers Association (PRMA) created
an index to measure productivity on a ...
Going Manual: Preparation for a CyberAttack Among Puerto Rico’s Electrical Grid System Personnel
(Polytechnic University of Puerto Rico, 2019-08-19)
This research project was intended to assess the ability for Puerto Rico’s power grid administrative authorities to respond to a cyberattack like the one documented in Ukraine in December 2015 The researcher gathered ...
Distributed Electric Propulsion
(Polytechnic University of Puerto Rico, 2019-08-19)
This investigation focused on predicting aerodynamic improvements obtained when air is blown over a wing by six propellers distributed equally along the wing’s span The purpose was to validate a method to implement Distributed ...
Carbon Nitride Polymer Nanocomposite Anion Exchange Membranes
(Polytechnic University of Puerto Rico, 2019-08-19)
This work proposes the fabrication of novel polymeric membranes to overcome some limitations of the existing AEMs, such as their low OH conductivity and poor chemical stability in KOH
Mejoras de Proceso en una Línea de Producción
(Polytechnic University of Puerto Rico, 2019)
El siguiente proyecto se llevó a cabo mediante la implementación de la metodología DMAIC en conjunto a la de 6S, buscando como resultado aumentar la eficiencia en una línea de producción. Este proyecto forma parte de la ...
Control licenses area optimization
(Polytechnic University of Puerto Rico, 2019)
When working in a company that
contains processes regulated by state and federal
agencies, any task performed by staff is critical.
Especially when the company supplies products
that are consumed by people. A controlled ...
Reducción de unidades defectuosas en el área de ensamblaje en una compañía de dispositivos médicos
(Polytechnic University of Puerto Rico, 2019)
Según estadísticas evaluadas
semanalmente se está notando una alza de
desperdicios en el área de ensamblaje de la línea
de producción del Producto M. La compañía se
está afectando económicamente con un total
semanal ...
Particle detection tool for liquid product inspection machines
(Polytechnic University of Puerto Rico, 2019)
Improvements opportunities were found
during the inspection process of recent
manufactured lots in new manufacturing single-use
technology, which was validated due to expected
increase in product demand. An increase ...
Impact of lean in the inventory process of a clinical laboratory
(Polytechnic University of Puerto Rico, 2019)
The inventory process of clinical
laboratories was evaluated to detect common
problems, waste and identify areas of improvement.
The objective of this project was to assess the impact
of lean in health care environment. ...
Printed board assemblies test coverage calculation: new calculation method
(Polytechnic University of Puerto Rico, 2019)
There are three ways that major
industries use to calculate Printed Board Assemblies
Manufacturing Test Coverage. The problem with
these methods is that they combine parameters that
are either relative to inspection ...