Buscar
Mostrando ítems 11-19 de 19
Vial Leak Test Optimization
(Polytechnic University of Puerto Rico, 2021)
This paper describes the testing performed to determine the optimum operational parameters that will be used to operate the Mar-Tre Leak Testerfor the 12Z vial configurations. Based on the results obtained, ...
Cleaning Validation of a Manufacturing Line using CIP-100 Detergent and a Clean-in-place Skid System
(Polytechnic University of Puerto Rico, 2022)
Cleaning Validation is a prime element of control to the cross contamination and potential carry over topic at the manufacturing industry. This process must assure the quality, safety and efficiency of cleaning ...
Evaluation to Sleeves Used in Granulation Department for the Graduate Programs at Polytechnic University of Puerto Rico
(Polytechnic University of Puerto Rico, 2021)
The DMAIC methodology was applied to analyze a manufacturing system at Johnson & Johnson Pharmaceuticalsin Las Piedras, Puerto Rico. The methodology was used to improve the time for changing and ...
Recomendaciones para la Mitigación de Eventos de Control de Plagas en Áreas de Manufactura de Industria Farmacéutica Ubicada en Gurabo, PR
(Polytechnic University of Puerto Rico, 2022)
Debido al alza en eventos de control de plagas en una industria farmacéutica ubicada en el área de Gurabo es que se realizó esta investigación. La palabra plaga significa cualquier animal o insecto no deseado ...
Execution of Lean Techniques for Cost improvement in a Quality Area of a Small Regulated Company established in Puerto Rico
(Polytechnic University of Puerto Rico, 2022)
A small regulated company established in Puerto Rico developed a cost improvement project on a Quality Area to stay competitive. The main objective was to reduce the number of samples sampled ...
Inventario y 5s en un Laboratorio de Control de Calidad
(Polytechnic University of Puerto Rico, 2022)
Un laboratorio de control de calidad de una farmacéutica es el encargado de asegurar la calidad del producto que allí es manufacturado. Por medio de esta investigación se busca implementar la metodología de 5S y de ...
Process Time Reduction in Manufacturing Areas: Visual Valves Identification on Manufacturing Area specifically on Media Prep Area, Media Preparation tanks to Pursue Agility on the Visual inspections required before, during and after the Media Prep Solution are Prepared
(Polytechnic University of Puerto Rico, 2022)
Time of production process and associate activities were evaluated for Media Prep manufacturing process on Juncos, P.R. The voice of the customer requested reduced time inspection process before, ...
Strategy for the Reduction of False Rejects in the Visual Inspection of Injectable Drug Products
(Polytechnic University of Puerto Rico, 2022)
A hundred percent visual inspection is performed as part of the manufacturing process of injectable drug products as a regulatory
requirement to detect and remove units with defects to protect the patients. The rejection ...
Setup Time Reduction in the Water for Injection Sampling Process on the Pharmaceutical Industry
(Polytechnic University of Puerto Rico, 2020)
This work consists in the development of
a new WFI sampling route that will bring several
important benefits to the pharmaceutical industry.
Reduction in the setup time will improve daily
operations in terms of efficiency, ...