Buscar
Mostrando ítems 71-80 de 132
Implementation of evaporator to minimize wastewater disposal
(Polytechnic University of Puerto Rico, 2019)
The medical device company currently
has two areas in which the processes generate
wastewater classified as Non-Hazardous. The
current process involves expenses to subcontracted
services for disposal, recurrent purchasing ...
Increasing the eficiency of Pitorro’s production
(Polytechnic University of Puerto Rico, 2018)
Puerto Rico has produced Rum since
early ages and is part of its culture. But the rum
making process has been an irregular one since the
process has been passed through generations and
the persons who make it don’t ...
Control licenses area optimization
(Polytechnic University of Puerto Rico, 2019)
When working in a company that
contains processes regulated by state and federal
agencies, any task performed by staff is critical.
Especially when the company supplies products
that are consumed by people. A controlled ...
Reducción de unidades defectuosas en el área de ensamblaje en una compañía de dispositivos médicos
(Polytechnic University of Puerto Rico, 2019)
Según estadísticas evaluadas
semanalmente se está notando una alza de
desperdicios en el área de ensamblaje de la línea
de producción del Producto M. La compañía se
está afectando económicamente con un total
semanal ...
Impact of lean in the inventory process of a clinical laboratory
(Polytechnic University of Puerto Rico, 2019)
The inventory process of clinical
laboratories was evaluated to detect common
problems, waste and identify areas of improvement.
The objective of this project was to assess the impact
of lean in health care environment. ...
Printed board assemblies test coverage calculation: new calculation method
(Polytechnic University of Puerto Rico, 2019)
There are three ways that major
industries use to calculate Printed Board Assemblies
Manufacturing Test Coverage. The problem with
these methods is that they combine parameters that
are either relative to inspection ...
Mejoramiento de Áreas de Manufactura Utilizando Kanban y 5S
(Polytechnic University of Puerto Rico, 2018)
Un dispositivo médico es un producto
que puede ser una máquina, un instrumento, un
implante, o un reactivo in vitro, destinado a usarse
en el diagnóstico, la prevención y el tratamiento de
enfermedades u otras afecciones ...
Medical Device Manufacturing Area Waste Elimination and Efficiency Improvements Project
(Polytechnic University of Puerto Rico, 2018)
This project describes a process for
waste elimination and efficiency improvements in a
manufacturing area at a medical device company.
It uses the DMAIC methodology for the
development of the improvements. Throughout ...
Improve Compliance to Schedule
(Polytechnic University of Puerto Rico, 2018)
One of the most difficulties in manufacturing is to explain the production colleagues the importance of following a production schedule and deliver product on-time to the next process. The facility in where this research ...
Develop an organization system that allows to optimize and automate the process of access to files
(Polytechnic University of Puerto Rico, 2018)
A company has an excess of archived
documents that go from 2003 to the present. The
excess of files has limited the space in the office
and the work of the employees. It also causes a very
large monetary expenditure ...