| dc.rights.license | All rights reserved | en_US |
| dc.contributor.advisor | Pons Fontana, Carlos A. | |
| dc.contributor.author | Pérez Cruz, Gerald F. | |
| dc.date.accessioned | 2021-01-25T14:02:33Z | |
| dc.date.available | 2021-01-25T14:02:33Z | |
| dc.date.issued | 2020 | |
| dc.identifier.citation | Pérez Cruz, G. F. (2020). Measured process identification [Unpublished manuscript]. Graduate School, Polytechnic University of Puerto Rico. | en_US |
| dc.identifier.uri | http://hdl.handle.net/20.500.12475/1045 | |
| dc.description | Design Project Article for the Graduate Programs at Polytechnic University of Puerto Rico | en_US |
| dc.description.abstract | This project is created to reduced scrap
and redirect the actual process of the bending and
fabrication of tubes and hoses expressly made for
aerospace purpose at Eaton Aerospace. The bend
process consists on the manipulation of a straight
tube giving different direction, angles and rotations
to achieve a different form or contour on the tube.
Parts could get to have over 20 bend in the same tube
and get to measure more than 3 ft. Everything will
depend on the design and structure needed on the
aircrafts.
Key terms ⎯ bend, Clark fixture, MYLAR,
orientation | en_US |
| dc.language.iso | en_US | en_US |
| dc.publisher | Polytechnic University of Puerto Rico | en_US |
| dc.relation.ispartof | Manufacturing Engineering; | |
| dc.relation.ispartofseries | Spring-2020; | |
| dc.relation.haspart | San Juan | en_US |
| dc.subject.lcsh | Polytechnic University of Puerto Rico--Graduate students--Research | en_US |
| dc.subject.lcsh | Six sigma (Quality control standard) | |
| dc.subject.lcsh | Polytechnic University of Puerto Rico--Graduate students--Posters | |
| dc.subject.lcsh | Scrap metals | |
| dc.subject.lcsh | Tube bending | |
| dc.title | Measured Process Identification | en_US |
| dc.type | Article | en_US |
| dc.rights.holder | Polytechnic University of Puerto Rico, Graduate School | en_US |
