Buscar
Mostrando ítems 51-60 de 159
Lean transformation strategic journey: from an ordinary manufacturing site towards a world class manufacturing site
(Polytechnic University of Puerto Rico, 2019)
The MDP Company is a global medical
device leader company in musculoskeletal
healthcare market. One of its primaries
manufacturing facilities is located in Puerto Rico
where orthopedic implants and reconstructive
products ...
Glow Discharge Plasma Sterilization of Prokaryotic Microorganism Through Electrostatic Plasma
(Polytechnic University of Puerto Rico, 2019-08-19)
Sterilization/disinfection of target bacteria – Bacillus Subtilis – is investigated using plasma sterilization process which involves both Dielectric Barrier Discharge Plasma (DBD) and Glow Discharge
Plasma. The purpose ...
Alternatives for Processing Plastics with Recycle Codes from 3 to 7
(Polytechnic University of Puerto Rico, 2019-08-19)
Solid waste management represents a challenge for Puerto Rico. According to the Department of Natural and Environmental Resources (2019), more than half of the landfills have a closure order and only type one and two ...
The 2017-2018 Evaluation of the National Operational Excellence Index in Puerto Rico
(Polytechnic University of Puerto Rico, 2019-08-19)
Puerto Rico has not participated in the evaluation of the World Forum Competitive Index
(WFCI) since 2015; consequently, the Puerto Rico Manufacturers Association (PRMA) created
an index to measure productivity on a ...
Going Manual: Preparation for a CyberAttack Among Puerto Rico’s Electrical Grid System Personnel
(Polytechnic University of Puerto Rico, 2019-08-19)
This research project was intended to assess the ability for Puerto Rico’s power grid administrative authorities to respond to a cyberattack like the one documented in Ukraine in December 2015 The researcher gathered ...
Distributed Electric Propulsion
(Polytechnic University of Puerto Rico, 2019-08-19)
This investigation focused on predicting aerodynamic improvements obtained when air is blown over a wing by six propellers distributed equally along the wing’s span The purpose was to validate a method to implement Distributed ...
Carbon Nitride Polymer Nanocomposite Anion Exchange Membranes
(Polytechnic University of Puerto Rico, 2019-08-19)
This work proposes the fabrication of novel polymeric membranes to overcome some limitations of the existing AEMs, such as their low OH conductivity and poor chemical stability in KOH
Mejoras de Proceso en una Línea de Producción
(Polytechnic University of Puerto Rico, 2019)
El siguiente proyecto se llevó a cabo mediante la implementación de la metodología DMAIC en conjunto a la de 6S, buscando como resultado aumentar la eficiencia en una línea de producción. Este proyecto forma parte de la ...
Control licenses area optimization
(Polytechnic University of Puerto Rico, 2019)
When working in a company that
contains processes regulated by state and federal
agencies, any task performed by staff is critical.
Especially when the company supplies products
that are consumed by people. A controlled ...
Reducción de unidades defectuosas en el área de ensamblaje en una compañía de dispositivos médicos
(Polytechnic University of Puerto Rico, 2019)
Según estadísticas evaluadas
semanalmente se está notando una alza de
desperdicios en el área de ensamblaje de la línea
de producción del Producto M. La compañía se
está afectando económicamente con un total
semanal ...