Suche
Anzeige der Dokumente 1-10 von 17
Determination of In-Processing Manufacturing Impact into Elution Rate of Drug Eluting Steroid Collars
(Polytechnic University of Puerto Rico, 2012)
Abstract - The Food and Drug Administration provides regulations for combination products. The medical device industry needs to comply with these regulations specifically in products containing drug. One of the many ...
Validation of a New Procedure for a Pacemaker Component
(Polytechnic University of Puerto Rico, 2012)
Abstract - Company X manufactures pacemakers in Puerto Rico. Over the past years, Company X has been having a significant amount of complaints due to the septum component contained in its pacemakers. Doctors have claimed ...
Time Cycle Reduction of the Scrap Process in a Medical Device Company
(Polytechnic University of Puerto Rico, 2011)
As part of an assessment performed for continuous improvement it was identified that the Nonconformance (NC) Timeline metric shows 23% over the goal of 30 days closure. From the list of NC Reports (NCR) impacting this ...
PRM Operations Cores Cell Takt Time Kaizen
(Polytechnic University of Puerto Rico, 2015)
This article refers to, how UTAS handles
the optimization of a CORE a cell in the
manufacturing process. Companies have waste that
can be reduce with an optimization of the
manufacturing process. Steps to accomplish ...
Installation of a New Cognex Vision System for Quality Inspection on PDS (ATS5889) Machine at Surgical Device Company in the Eastern Region of Puerto Rico
(Polytechnic University of Puerto Rico, 2014)
There is a 4-6% scrap on PDS
(Protected Disposable Scalpel) machine actual
vision system. It is important for the company to
manage more efficiently and try to reduce scrap
percentage through the entire process of the ...
Reduction of Scrap in Manufacturing Line B-1 Using Six Sigma Manufacturing Methodology
(Polytechnic University of Puerto Rico, 2012)
Abstract - In this research, the focus was in a manufacturing production line of receptacles assembly. The receptacles are the finish good of this production line. In this process the receptacle is build completely starting ...
Packaging Line Efficiency Improvements with the Implementation of a Centralized Packaging Line Control System
(Polytechnic University of Puerto Rico, 2015)
Efficiency is a process measurement of
the ability of generating a required output with the
minimum amount of resources. A high efficiency is
crucial for a packaging line as it is an important
aspect of cost control ...
Combination Products Regulation – A Guide to Compliance
(Polytechnic University of Puerto Rico, 2015)
The Food and Drug Administration
(FDA or Agency) has issued a regulation on the
current good manufacturing practices (CGMP’s)
requirements applicable to combination products.
The new rule is intended to promote the ...
Increasing Capacity by Designing a New Drying Process at a Manufacturing Plant
(Polytechnic University of Puerto Rico, 2012)
Abstract ⎯ High oil price is one of the major factors for this twenty-first century global economic recession. Inevitably everyone’s mindset has changed towards energy and the focus is towards finding renewable energy that ...
Reduction of Time in a Manufacturing Process for a Pharmaceutical Company Located in Puerto Rico
(Polytechnic University of Puerto Rico, 2012)
Abstract - The project is developed in a chemical plant of a pharmaceutical company in Puerto Rico. In 2011 the company had an increase in market demand of the active ingredient of one product. To ensure the profit plan, ...