Zur Kurzanzeige

dc.rights.licenseAll rights reserveden_US
dc.contributor.advisorPons Fontana, Carlos A.
dc.contributor.authorPérez Cruz, Gerald F.
dc.date.accessioned2021-01-25T14:02:33Z
dc.date.available2021-01-25T14:02:33Z
dc.date.issued2020
dc.identifier.citationPérez Cruz, G. F. (2020). Measured process identification [Unpublished manuscript]. Graduate School, Polytechnic University of Puerto Rico.en_US
dc.identifier.urihttp://hdl.handle.net/20.500.12475/1045
dc.descriptionDesign Project Article for the Graduate Programs at Polytechnic University of Puerto Ricoen_US
dc.description.abstractThis project is created to reduced scrap and redirect the actual process of the bending and fabrication of tubes and hoses expressly made for aerospace purpose at Eaton Aerospace. The bend process consists on the manipulation of a straight tube giving different direction, angles and rotations to achieve a different form or contour on the tube. Parts could get to have over 20 bend in the same tube and get to measure more than 3 ft. Everything will depend on the design and structure needed on the aircrafts. Key terms ⎯ bend, Clark fixture, MYLAR, orientationen_US
dc.language.isoen_USen_US
dc.publisherPolytechnic University of Puerto Ricoen_US
dc.relation.ispartofManufacturing Engineering;
dc.relation.ispartofseriesSpring-2020;
dc.relation.haspartSan Juanen_US
dc.subject.lcshPolytechnic University of Puerto Rico--Graduate students--Researchen_US
dc.subject.lcshSix sigma (Quality control standard)
dc.subject.lcshPolytechnic University of Puerto Rico--Graduate students--Posters
dc.subject.lcshScrap metals
dc.subject.lcshTube bending
dc.titleMeasured Process Identificationen_US
dc.typeArticleen_US
dc.rights.holderPolytechnic University of Puerto Rico, Graduate Schoolen_US


Dateien zu dieser Ressource

Thumbnail
Thumbnail

Das Dokument erscheint in:

Zur Kurzanzeige