Buscar
Mostrando ítems 11-20 de 28
Implementación de Proceso de Descarte de Productos Intravenosos en una Planta de Productos Farmacéuticos
(Polytechnic University of Puerto Rico, 2019)
Durante el pasado año, se
descartaron 2.7 millones de unidades debido a
distintos problemas de calidad. Baxter es una
compañía manufacturera de dispositivos médicos
que lleva 60 años en el pueblo de Jayuya, Puerto
Rico. ...
Optimization of a Pharmaceutical Filling Process to Comply with Federal Regulations and Minimize Process Variability
(Polytechnic University of Puerto Rico, 2019)
This article analyzes the scientific
methodology that was followed to solve a problem
that arose in a pharmaceutical installation after a
federal regulatory inspection. The route for a robust
solution was framed by a ...
Mejoras de Proceso en una Línea de Producción
(Polytechnic University of Puerto Rico, 2019)
El siguiente proyecto se llevó a cabo mediante la implementación de la metodología DMAIC en conjunto a la de 6S, buscando como resultado aumentar la eficiencia en una línea de producción. Este proyecto forma parte de la ...
Particle detection tool for liquid product inspection machines
(Polytechnic University of Puerto Rico, 2019)
Improvements opportunities were found
during the inspection process of recent
manufactured lots in new manufacturing single-use
technology, which was validated due to expected
increase in product demand. An increase ...
Validation Documents Process Optimization and Cost Reduction
(Polytechnic University of Puerto Rico, 2019)
Every manufacturing and regulated site, performs multiple Validation Documents; being this area one of the most material cost and man hour consuming of the site. FMEA and Design Documents are constantly generated and revised ...
In-process Testing Redesign in Packaging Line of Oral Solid Dosage
(Polytechnic University of Puerto Rico, 2019)
Packaging process area request to
redesign the in-process testing to reduce waste and
increase the efficiency during the in-process testing
activities without increase in the defective unit
found by Quality during their ...
Implementation of Lean Methodologies in the Small Radiology Firm Bayamón Radiology Center
(Polytechnic University of Puerto Rico, 2019)
The Lean methodology was used to
reduce examination cycle and lead times for the
radiology clinic Bayamon Radiology Center. They
clinic had a conventional X-ray system that uses
x-ray films. Voice of the Customer and ...
Improving the custom-built applications computerized system validation lifecycle for a medical device company
(Polytechnic University of Puerto Rico, 2019)
This research project was focused in the
improvement of the Custom-Built Applications
Computerized System Validation Lifecycle for a
Medical Device Company. A Computerized System
Validation is the process of documenting ...
Yield improvement for anesthesia product at filling & packaging line
(Polytechnic University of Puerto Rico, 2019)
In the manufacturing process of
anesthesia, the yield for Fluxane product,
manufactured at ANESTHER Healthcare, is
consistently performing lower than target (2.785
bottles/kg) from tank F-SV-001 in comparison to
tank ...
Optimization of Tooling Design Process for Assembly of Motor Parts
(Polytechnic University of Puerto Rico, 2019)
This project developed a DMAIC process
to start improving the results of a new task been
performed in the company [1]. The project will
focus on improving the quality and turnaround time
of the work performed. the ...